28 September 2013

Locating and Repairing Bad Pixels

If you have pixels - be they nodes, modules or strip - at some point you are going to have a failure.  That failure could be when you purchase them or over a period of time due to physical damage or other causes.  So, you'll need to have the ability to locate and then replace the bad pixel.  This video shows how to perform this process on nodes (8mm / 12mm) but it also is the exact same process if you have any other type of pixel. 


As mentioned in the video, if you do pixels, you'll need to solder and it's not nearly as complex as you might expect.  Check YouTube for videos on how to solder.